This is a refurbished uninterruptible power supply/battery backup unit. It has been installed with brand new high-quality batteries, thoroughly tested and then professionally packed in a brand new box.

Features

• Double-Conversion Online Technology
• Sine Wave Output
• Automatic internal bypass Supplies utility power to the connected loads in the event of a UPS overload condition or fault.
• Scalable runtime Allows additional run time to be quickly added as needed.
• Hot-swappable batteries Ensures clean, uninterrupted power to protected equipment while batteries are being replaced
• Automatic restart of loads after UPS shutdown Automatically starts up the connected equipment upon the return of utility power.
• Network manageable Provides remote management of the UPS over the network.
• InfraStruXure Manager compatible Enables centralized management via the APC InfraStruXure® Manager.
• Plug-and-Play external batteries Ensures clean, uninterrupted power to the loads when adding extra runtime to the UPS.
• User-replaceable batteries Increases availability by allowing a trained user to perform upgrades and replacements of the batteries reducing Mean Time to Repair (MTTR)
• Frequency and voltage regulation Gives higher application availability by correcting poor frequency and voltage conditions without using the battery.
• Power conditioning Protects connected loads from surges, spikes, lightning, and other power disturbances.
• Generator compatible Ensures clean, uninterrupted power to the loads in the event of an extended power outage
• Cold-start capable Provides temporary battery power when the utility power is out.
• Resettable circuit breakers Enables a quick recovery from overload events.

Please note that these units do NOT have the floor stand shown in the picture above. This UPS may be placed flat on a shelf or on the ground without any problems since it is also designed to be installed in equipment racks and operate in a horizontal position.

Technical Specifications

Output

• Output Power Capacity 1400 Watts / 2000 VA
• Nominal Output Voltage 120V
• Output Voltage Distortion Less than 3%
• Waveform Type Sine wave
• Output Connections (6) NEMA 5-15R (Standard 3-prong receptacles)

Input

• Bypass Internal Bypass (Automatic and Manual)
• Nominal Input Voltage 120V
• Input Frequency 50/60 Hz +/- 5 Hz (auto sensing)
• Input Connection NEMA 5-20P (20 Amp 120V "T" plug)
• Input voltage range for main operations 90 - 150V

Batteries & Runtime

• Included Battery Modules 1
• Typical recharge time 3.00 hour(s)
• Replacement Battery UBC57, SURTA48XLBP
• Typical Backup Time at Half Load 15.2 minutes (700 Watts)
• Typical Backup Time at Full Load 5.0 minutes (1400 Watts)

Communications & Management

• Interface Port(s) DB-9 RS-232, USB, Smart-Slot
• Emergency Power Off (EPO) Yes

Surge Protection and Filtering

• Surge energy rating 540 Joules

Physical

• Height 17.00 inches (432 mm)
• Width 3.36 inches (85 mm)
• Depth 22.00 inches (559 mm)
• Rack Height 2U
• Net Weight 60.50 lbs. (27.50 kg)

Environmental

• Operating Environment 32 - 104 F (0 - 40 C)
• Audible noise at 1 meter from surface of unit 45.00 dBA
• Online Thermal Dissipation 587.00 BTU/hr

Conformance

• Regulatory Approvals CSA,FCC Part 15 Class A,UL 1778